Seven stages. One standard.

Every file is calibrated for our 16K printers and custom 16K resin, then produced in small batches to preserve sharp edges, texture and fine facial detail.

We remove the main supports by hand after printing. We do not sand or fully finish every contact point, so tiny support marks, small bumps or an occasional fine support may remain. A little normal hobby clean-up may be needed before priming.

The pieces enter an ultrasonic bath that lifts uncured resin from recesses without softening the sculpted detail.

Controlled centrifugal force clears trapped liquid from cavities and delicate geometry before the final cure.

Each part receives a timed, even cure for a durable finish that remains practical to assemble, prime and paint.

We inspect pose, fit, surface and vulnerable points. Anything below standard returns to the print queue.

Parts are separated, cushioned and boxed for transit, then shipped worldwide with tracked DDP delivery. GrafSyntheos handles applicable duties, taxes and customs clearance.